Leaderboard

Just keep in mind that the 6238 had a symmetric case, so the side where the crown sits is less thick than on a 6263. If you use a 6263 case with a smooth bezel, it wont look right. Rolex made the crown-side fatter than the other side when they started using 7mm crowns and screw-down pushers (although 6239s exist in both variations). Sent from my iPad using Tapatalk

It's been a while since we last saw V72-6238 projects here. I wonder what all the daytona experts are up to these days. My latest project:

PАМ04&"Axхе-Classic" series.

Look at the quality of Mods we have here. They are told it is 45mm and they guess 40mm and 42mm!!!

A few troublemakers in Utqiagvik

Looks gen and ugly[emoji38] Gesendet von meinem MI 4S mit Tapatalk

Cheers By-Tor. Mine is also my daily beater since a long time.[emoji106] Gesendet von meinem MI 4S mit Tapatalk

I have one incoming. I'll do a side by side with my gen sd4k

Simple mechanisms for me

PAM225 & REX by AXENOV85

Wore my DRSD today

panerai153, sir I cannot see your picture and could you try updating the link? alligoat, thanks for the comment! Sogeha, the Phong dial I started with had three flaws which can be seen in the pic below. 1. "G" instead of "6" Simply, the gap on the horizontal line was filled with paint! 2. Incorrect coronet (the one with a sharp edge was there) Got a gen 18k WG coronet and the original one was replaced with the gen. 3. Long indices Each index except at 5, 15 and 25 position was shortened by erasing partially. This was done under a microscope with a toothpick soaked in ethanol.