Leaderboard

They cannot. The only thing you can do is remove the marker, cut one foot off, and reinstall with glue. Very touchy process. Decide which foot to cut before you do it.

Or go the classic 5513 route, no date wheel replacement issues. A cartel base model with the Asian 2836 will be a nice start. Make sure it has the 93150 stamped bracelet. http://www.trustytime.club/index.php?main_page=product_info&cPath=1_11&products_id=14419 1. Replace the dial with a Helenarou one, comes in 3 variants of aging to choose from and already has the eta feet position. 2. Have the lug holes drilled so you can use gen spec fat spring bars, you ideally also need to reduce the inner crown guards so the gen crown has a gap either side. 3. change the plexi for a clarks T19 one, much nicer. Or just leave the rep one and age it a bit 4. Swap out the crown and tube for Gen, makes a big difference as the rep ones are all too tall in height. 5. Buy some WSO 580 endlinks off ebay Hope that helps DH Hers's one that i put together a while back using the Helenarou dial, best advise is remove the Cartel tube then this gives you plenty of filing room. The aim is to create a small gap between the inner CG and crown. Hope this helps

Sorry I didn't read yours properly

I may be in for 1.9mm bars. I’ll let you know before 15 may.