JJBliss

I'll trade your bezel for a non-blinged bezel + cash if you're interested......

Just out of curiosity for another project I'm working on: What constitutes gen like pushers? I've seen V2 Rep SA cases with "two part" pushers. Small pushers with loose pusher extenders that fit into the spacer ring to activate the mechanism, and V3 rep pushers that have long extenders that need the movement angled in toward the case to fit, but that won't work with a V2 movement ring, since the holes don't line up - In that case you'll need a V3 movement ring specifically with an open bottom on the edge to accomodate the extended pushers. Which is the accurate one for the gen?

HAWT!!!

I'm in NJ, but work in NY - fairly close to the diamond district as well. If you can PM me the name and or address, I will certainly stop in and see them. Especially if they can source and install the Gen parts.

What happened to the ridiculous thread in the Watches forum? Was it deleted?

SA tubes are part of the mid case on SA reps and cannot be replaced. Instead a new mid case and rep crown needs to be sourced. The problem is typically a bent tube at the time of initial assembly that causes a stripping of both the crown and tube. This is one of the many ways the Chinese replica is inferior to the genuine A TD should be able to get you a replacement case set for about $250.

Why would they do that????

Edge, Do you have the link for the RG thread. I participated in that thread, but it seems to be missing....

I think it's US based. And there was a thread about this over at RG, but now I can't find it. Anyone have a link?

There's an HKTan hornback for MH on sale at RG right now.

I'm desperately trying to get a Gen B13 movement installed in a brand new V3 case to finish my Franken SA. Looks like I didn't know enough to ask for the movement spacer ring that matches the V3 case I ordered. Apparently, there is a small difference between the movement spacer ring for the V2 case that I have and the one for the V3 case. It seems that the internal diameter of the V3 case is just 2mm (or so) narrower then the V2 case I am replacing and the spacer ring won't fit. Is this part available for the V3 case? Is there ANY chance in hell that any of you actually HAVE one of these here in the states. I've already tried Toro and he doesn't have access to this part. Below is the message I got from The Zigmeister in Canada about the V3 case I sent him: Can anyone help? I am willing to buy a broken (cosmetically or movement) V3 from someone and cannibalize it for the ring. Anyone? ----------- On Mon, Aug 27, 2012 at 9:32 AM, The Zigmeister wrote: The new case is missing its movement spacer ring. Old case versus new one is not the same or compatible - old inner diameter 39mm/new inner diameter 37mm - old = short pushers and extenders on spacer - new = long pushers and no extenders - need missing spacer - Please see ref photos.

I know - I love mine.... Thanks Dr. Theo....

So, on impulse, I bought a Gen Flying B bracelet to put on my rep Flying B when it comes back from being serviced. It occurs to me now (too late, I know) that since the rep speed bracelet was terribly tight, that the Gen bracelet may not fit. Does anyone have any experience they can share? I'm sure that I can use it on my Gen Motors-T or my Super Franken SA - but it really was intended to take the Flying B to a new level. Thoughts?

No no no. The Zigmeister is on vacation. Vac is still working albeit slowly since he's so backed up. It took almost three weeks for him to complete a 1 week pearl lume. Awesome work, and worth the wait but still a wait.

He is still on Vacation. Probably another week or so.