level z

ok. good luck.

see the first diagram if you wanna try a DIY ... http://www.ofrei.com/page558.html

or if you have a spare first wheel, you could try to check if it can work ... very unlikely the fault is with the shaft/pinion of the first wheel ...

i think it would be easier to replace the CP ... if you are gaming for some DIY .. you can try repair the cp .. see link ... http://mb.nawcc.org/showthread.php?22811-Loose-cannon-pinion i will try to find some pictorial later when i have the time as i have to do some work now ...

you have to confirm the hands are loose when fitted. You can try slightly moving the hand after being fitted to confirm if it is loose. The CP is fitted to the first wheel in such a way that it is allow to slight "somewhat slip like a clutch" but not overly loose ... If the hour hand is moving normally and the minute is not, then you need a staking tool to "tighten" up the CP.

dont file/sand off the bottom of the minute hand ... you may end up with minute and hour hand rubbing each other due to lack of clearence between them. Get a cannon pin tat is 3.15 mm like here http://www.tztoolshop.com/page151.html however you can find such sligtly higher CP in asian 6497 like those in rep watch. I pretty sure at the back of my head there is a differnece between the 18 kbph and the 21.6 kbph .. gearing size is not the same. hope this makes some sense to you and able to help u. cheers lz

I dont know if you gals and guys seen this before .. here goes ... Men's Pearls of Wisdom

Need funds for watch parts so putting up floor oscillating fan for sale .. fully working oscillating condition, only zero speed speed selection possible .. asking cheap .. open to offers

this really make me laughed till i teared .. hope you bring you some laughter too ... http://www.youtube.com/watch?v=nmxjWYY2zCk"

+1 .. the best hand remover i used .. mine is AF swiss ...good stuff

Hi ... it was gotten thru Hont ... well this is tobacco and 177 is black dial ... my opinion is the 61 is uncommon as compared to 177 so will get more attention ... just my 2 cents regards lz

... fren refuse to accept payment and i dare not ask as a gift ... so it is on long term/permanent loan ..lol