Hello all! I recently started a Tudor 9401/0 submariner build and am in need of some clarifications. But before we get into that, here’s the build so far! It all started when I purchased a Tudor Submariner from Japan auctions, hoping it was at least a franken. Turns out it’s most likely a complete rep but considering what I paid for it, some parts were worth keeping and building upon. Here’s a breakdown of the parts I’ve kept and added so far: • Case: not sure of the source, came with the watch • Dial: Phong • Bezel: Phong • Bezel insert & pip: Crownartcustoms (ig) • Hands: Hour & minute from wholesaleoutlet990 (eBay), gen seconds hand • Crown: came with watch, gen 24-703 crown and tube incoming • Movement: came with an eta 2824-2 but haven’t verified it’s authenticity I’m hoping to eventually add a gen dial and maybe a gen 93150 bracelet. A matching relume is also in order. Now, back to the matter at hand. I recently upgraded to a phong bezel but I’m not sure if the retaining ring is fitting the case well. Is the retainer ring supposed to sit flush and tight against the case or sit slightly elevated? I thought retaining rings sat flush against their case but this being a tension (push down) bezel, is it supposed to have a small gap so as to not rub the bezel against the case when rotating? The phong retaining bezel is either a perfect fit (sits slightly above case) or too small (not flush) and may need some customizing. Hopefully someone here can give some clarification on this. Everything else seems to be a perfect fit so far but if anyone has any suggestions on what should be done/upgraded next, let’s hear it. Thanks!