Cashxxx

Which part number was it?

its the "Omega 1580 Clasp Attaching Link "

I gave an 'informative' rating, because I always think the best of every newbie.

But without pics, it is close to being spam -- that ID gives me the heebees too.

Never mind. Photos will quell any doubts.

Im hardly a newbie, just new to this forum. Normally I would agree about the pic comment, but this is kind of a hard one to demonstrate with pictures. I didnt take a pic of the gap in the bracelet before fixing it but if you own this watch then you know what I mean. The picture below of a gen bracelet can show you where the pin holes are on the rep (red). Just imagine that on the rep that last link before the clasp turns at a 90 degree angle to it as opposed to lying flush like the pic.

How much does The Zigmeister charge for these mods?

If you own a Omega PO 42mm then youll know that the end link and clasp do not sit right and are one of the biggest flaws of the watch. I finnally found a solution!

Genuine parts from Ofrei.

Ofrei sells "clasp attaching links" for the PO with the correct pin hole placement to prevent the end link from turning at an angle from the clasp thus leaving the bracelet perfect on the wrist. I paid about $55 including shipping for two of these; well spent cash in my opinion.

Now the only flaws remaining are lume, double AR coating (not really sure about this after seeing gen), and serial on back.

P.S. the end link is probobly the hardest link to remove on the bracelet. Have patience.