Problem with my new PAM250 with A7753

[mene_menelaou]

I've received my PAM250 with Asian 7753 yesterday.

My problem is that the chronos doesn't working at all.

When I push the button at 2 the watch stops, if I push it again it starts (I mean the secondhand at 9). The button at 4 does not do anything.

I should note that when I've opened the box the chronograph was activated and as usually, I've stoped it and everything was OK, I mean everything reset to zero.

The problem appeared when I've tried to use it today.

Anyone with the same issue?

[wheaton26]

i would contact your seller and get a replacement. unfortunately this means sending it back on your dime. good luck!

[nleap]

I am having a few problems with mine too.. but not with the chrono... the power runs out, even when i am wearing it, so i have to wind it by hand every other day. Its almost like I have a 111 hand wound movement... sucks. I am not sure what I am going to do about it. by the time I discovered it, it had already been a few weeks.

Edited November 11, 2010 by nleap

[sizzlesam]

I have been wearing my 236 since it has arrived, but last week I went with my gen Sinn u2. I noticed my power reserve was terrible, about 6 hours if off my wrist. For something less than 30 days old this is unacceptable. I am guessing its the movement issues everyone else is complaining about.