lemonvr6 Posted December 6, 2006 Report Share Posted December 6, 2006 TT sub. I can't figure out how to release the bracelet from the case. There are no holes on the sides... Quote Link to comment Share on other sites More sharing options...
FlipLockBuckle Posted December 6, 2006 Report Share Posted December 6, 2006 (edited) This is how i did it. Due to the fact, that you have no holes in the case, the bracelet-endlinks prolly are not solid, so you can see the pin that connects bracelet-endlink to the case. You will see, that the pins have a little Ring at both ends...take a look at this: http://img.auctiva.com/imgdata/1/5/4/2/6/8...13830293_tp.jpg This "Ring" can be seen through the hole in the bracelet-endlinks. Just take a needle, set it just on the ring, and push it in. Once youi have pushed it in you can loosen one side of the endlink by pulling on the endlink just enough so the springbar pin will not snap back into the case hole. Do the same thing with the other side and there you go Edited December 6, 2006 by FlipLockBuckle Quote Link to comment Share on other sites More sharing options...
narikaa Posted December 6, 2006 Report Share Posted December 6, 2006 Needle!!!! Failing that just get the correct tool for the job http://www.rwg.cc/members/index.php?showtopic=5941 . Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.