Bracelet sizing on GMT II Ceramic

[gizmopop]

Just removing links leaves the watch either too loose or too tight on my wrist so I need a way to do a finer adjustment. I'm not aware of any half links available so there must be some way to size the existing bracelet. The only way I can see to make this adjustment is to move the attach point in the clasp. However, there isn't a slot or any visible way to release the pin there. There must be some way...

[hank7502]

There is a little slot on top of the spring bar that is in the clasp. Take a small screwdriver or spring bar tool, put it in there and push down.

[gizmopop]

There are the slots in the clasp to move but if you move that end then the clasp doesn't work. It seems like I should be able to move the bracelet in the clasp but there's no way to do that from what I can tell. I have a sub that has holes in the sides of the clasp to make this adjustment - none on this one though.

[Spirit]

...It

[gizmopop]

Thanks, Spirit. I didn't know about the Comfort Link so I will check this. I also found this site that has pictures although it is from a gen I'm pretty sure - [url=http://oohlins.blogspot.com/2007/06/rolex-series-6-quick-adjustment-link.html]. My bracelet is in the leftmost position in the clasp instead of the right side as shown in the photos. I also do not have the slots in the end of my bracelet.

(Sorry, can't get that hyperlink to work there.)