bruce79 Posted June 10, 2009 Report Share Posted June 10, 2009 So I uncased the A6497 in one of my pams to remove the AR on the crystal...something I've done many times before. When I went to insert the stem back into the movement, after tightening the screw the tiny screw that secures the stem into the movement, I cannot wind the watch. The crown is in the wind position but advances the hands instead of winding the movement. Usually you have to pull the crown out and push it back in to engage the winding mech (don't know the term) but I cannot pull the crown out far enough. I don't want to yank on it and risk breaking the stem off. Is there anyone here that can offer any insight? I've never seen this one before. Quote Link to comment Share on other sites More sharing options...
l3x Posted June 10, 2009 Report Share Posted June 10, 2009 Are you sure the stem is all the way in? Release the stem screw one or two more turns and try to stick it all the way in. Then tighten it. Then move it into the setting time position and push it back in and try to wind it. Quote Link to comment Share on other sites More sharing options...
bruce79 Posted June 11, 2009 Author Report Share Posted June 11, 2009 I'll try unscrewing the screw a little more but as it is now the screw holds the stem in and will not allow me to pull it out. Thanks for your response. Quote Link to comment Share on other sites More sharing options...
l3x Posted June 11, 2009 Report Share Posted June 11, 2009 I'll try unscrewing the screw a little more but as it is now the screw holds the stem in and will not allow me to pull it out. Thanks for your response. If the stem screw is too tight you will have a difficult time putting it into the set time position. In this case just turn it 1/4 to 1/2 turn and retry. Quote Link to comment Share on other sites More sharing options...
bwhitesox Posted June 11, 2009 Report Share Posted June 11, 2009 J you may have to reset the keyless works mate. I have done it and it is really easy to do...Just follow the animated ETA swisslab from the link below. http://www.eta.ch/swisslab/6497/6947.html Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.