Where to find these little metal internal pushers?

[JohnDorian]

Lost them for a IWC Spitfire Chrono... any ideas what might be suitable replacements?

Here is the attachment

[JohnDorian]

Help?

[capice]

sounds obvious maybe but did you try the dealer....people who have acces to th factories would be able to supply these, or you must be luckyto get a scrapwatch with the innerpushers....

[JohnDorian]

Dealers not very helpful...

[RWG Technical]

If I need one, I make it out of my stock of misc sized stainless steel pins...

[JohnDorian]

I was thinking maybe solder from a soldering iron might do, I gotta run to the hardware store.

[Logan]

Solder will be far to soft.. I've made them in the past from 2mm stainless rod. A proper watch makers lathe would be ideal, but I used a dremmel type tool and ground the ends down to flat with a grinding stone.

Hole the pin in the dremmel chuck, manually hold the stone against the spinning part.

[JohnDorian]

WHat about just a nail? I've ordered a dremel in order to try it out.