how to digest bezel in pam 187

[ddebo]

Hi RWG~~

i am Daegari~

i am really wondered how to digest bezel from case about PAM 187

if you know that, please let me know that, i will be very appreciated for that

i want to custom bezel lume dot

it is so green. i hate that

i will wait for your heip~~

Good night

Daegari~

[Logan]

The bezel fits using the usual wire retaining ring, but its quite heavy so takes some serious force to remove it. The bezel markers are all glued in place including the 12 with the lume dot.

[big eebee]

Dont know if its the same

but my 243 bezel has no wire ring

just flips off with a case back remover

the push kind.

[ddebo]

The bezel fits using the usual wire retaining ring, but its quite heavy so takes some serious force to remove it. The bezel markers are all glued in place including the 12 with the lume dot.

Thanks logan

it means if i pull out bezel, i can not custom my lume dot?

Dont know if its the same

but my 243 bezel has no wire ring

just flips off with a case back remover

the push kind.

thanks eebee

it depend on the model

[Logan]

Removing the bezel won't help with the lume dot, there is no hole in the back of the bezel, You'd need to remove the triangular bezel marker, or perhaps drill the existing lume out from the front without removing it.

I removed the markers using heat (gas burner) to weaken the epoxy holding them in place, then broke the markers out from the glue.. but I was doing this on a throw away case.