blackbard Posted December 9, 2009 Report Share Posted December 9, 2009 Before anyone offers that I should use spring bars..... I would like to know what the lug tap size is for a genuine Panerai lug is to repair bad lugs. I have spring bars, but would like to make the repair because I actually prefer screws. Just looking for the tap size so that I can repair any ones that I run across. Thanks in advance! Quote Link to comment Share on other sites More sharing options...
Bike Mike Posted December 9, 2009 Report Share Posted December 9, 2009 Good question. Maybe Z can chime in as I he would be the one with a watchmakers tap & die set. Can you measure the Diameter of the treads on the pin? This should tell you. Here is the link to Ofrei. Of course I would not doubt this is some bastardized size. Quote Link to comment Share on other sites More sharing options...
blackbard Posted December 10, 2009 Author Report Share Posted December 10, 2009 Thread end diameter: 1.28mm measured with digital calipers 3 times...Need thread pitch... Quote Link to comment Share on other sites More sharing options...
Bike Mike Posted December 10, 2009 Report Share Posted December 10, 2009 Thread end diameter: 1.28mm measured with digital calipers 3 times...Need thread pitch... I don't think thread pitch exists when you are dealing taps this small. UNC, UNF, UNSF are out the window and this size.....could be wrong. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.