standready11 Posted April 17, 2010 Report Share Posted April 17, 2010 Hi folks. I wanted to know if anyone has been successful in moving the crown lower so the pushers and crown are staggered as they should be and not inline? Maybe those older expensive mbws? Thank you. Quote Link to comment Share on other sites More sharing options...
Katerchen Posted April 17, 2010 Report Share Posted April 17, 2010 Hi folks. I wanted to know if anyone has been successful in moving the crown lower so the pushers and crown are staggered as they should be and not inline? Maybe those older expensive mbws? Thank you. That someone (what i DOUBT) is going to relocate the pushers at AP ROO rep is nearly of the same effort as going for the goal of machining an entire NEW case for the rep. Only thing you can perform on an easy way is to relocate the tube by removing the old - then closing the hole with a metal-bolt, redrill the hole - inserting a new (or the old tube) to the desired location. Now if you think this was (dont forget beveling and refinishing) an easy task, then try to "relocate" the 2 pushers that easy! B/R George Quote Link to comment Share on other sites More sharing options...
Watchmeister Posted April 18, 2010 Report Share Posted April 18, 2010 I started with one of the MBW's and since then have been there and done it a couple of times. Quote Link to comment Share on other sites More sharing options...
Katerchen Posted April 18, 2010 Report Share Posted April 18, 2010 Yeah - listen to Watchmeister he has been "there". BTW hello friend George Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.