Modding question: possible to get crown closer to case

[rogerthat]

Without use or dremel or any type of power tool

Have a manual wind Pam that I think would look better if the crown was just a touch closer to the case allowing for the CG level to close just a little more down

Not sure if trimming the stem would be the answer or somehow trimming the outer nut or whatever it is before the crown?

I assume this has been done before?

[krpster]

You may need to do both depending on how it is setup now. But yes it is possible to do.

First remove the crown from the stem and trial fit to the tube on the case. You may actually find it fits better than the stem will allow.

Next work the tube using small fine file / sand paper. Check fitment often. Continue until appearance as desired.

Next refit crown to stem, insert to watch and check clearance at tube. If needed adjust length of stem so that the crown has just a small gap in winding position.

Finally you may need to adjust fit of CG as it may now be too loose.