dbane883 Posted January 7, 2013 Report Posted January 7, 2013 (edited) Removed the paint on the bezel from the V2 3135 last night: Applied acetone with a small brush and wiped it away. Easy peasy. If I have the energy, I will apply the platinum paint tonight. Ideally I should have removed the pearl, but like the noobs, the damn bezel won't come off. I also don't want to twist it off with pliers as it might crack the ceramic. Painting around the pearl will be a challenge. Here's a before pic: Edited January 7, 2013 by dbane883
gmtlover Posted January 7, 2013 Report Posted January 7, 2013 Maybe an advice, remove the pearl with a knife. Heat the insert with a hair dryer or heatgun. Then make a little hook from a paperclip and stick it in the hole from the pearl.. Now gently pull it up.. When the insert comes up then work your way around your bezel and out the insert comes! Goodluck!
dbane883 Posted January 7, 2013 Author Report Posted January 7, 2013 Maybe an advice, remove the pearl with a knife. Heat the insert with a hair dryer or heatgun. Then make a little hook from a paperclip and stick it in the hole from the pearl.. Now gently pull it up.. When the insert comes up then work your way around your bezel and out the insert comes! Goodluck! I know that works with the steel bezels, but the raised sub c pearls seem to be epoxied on. Not sure a knife will work. I'll try tonight.
gmtlover Posted January 7, 2013 Report Posted January 7, 2013 I did it with my DSSD no problem what so ever.. And that is a ceramic insert ;-)
dbane883 Posted January 7, 2013 Author Report Posted January 7, 2013 I did it with my DSSD no problem what so ever.. And that is a ceramic insert ;-) Ok. So razor blade around the pearl to pop it off. What did u use to glue it back on? Hypo cement?
gmtlover Posted January 7, 2013 Report Posted January 7, 2013 No same as what Was originally there. Double sided 3M tape. I tried glue first. But after I noticed the the insert was to low. So then I used 3m double sided tape and the height was correct again. Don't forget to heat it before you start pulling it up
dbane883 Posted January 7, 2013 Author Report Posted January 7, 2013 No same as what Was originally there. Double sided 3M tape. I tried glue first. But after I noticed the the insert was to low. So then I used 3m double sided tape and the height was correct again. Don't forget to heat it before you start pulling it up I was referring more about the pearl. I think I will epoxy it back on as it sticks up more so that any other Rolex pearls.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now