AyJayKay Posted July 11, 2015 Report Share Posted July 11, 2015 I have a rep Submariner 116610 with an ETA 2836-2 movement. It keeps excellent time and wears well. The problem is that the markings are coming off the 'ceramic' bezel insert. The engraving is not very deep and the grey/silver paint is coming off. I managed to get a replacement (rep) bezel insert, but am struggling to remove the old one. I have tried to lift the edge of the bezel as for the older Subs, but this one does not budge. I have tried the suggestion of heating the insert and using something sticky to lift the insert out of the bezel, but that does not work either. Now I am considering using a pair of pliers to grip the bezel on two sides and then to simply pull. I will obviously put something between the bezel and the pliers teeth to protect the bezel. Is this likely to work? Any other suggestions? Quote Link to comment Share on other sites More sharing options...
SSTEEL Posted July 11, 2015 Report Share Posted July 11, 2015 Heat the bezel insert up using an hair dryer. Best done with the movement removed to be safe. The heat will soften the double sided tape that holds the ceramic insert on the bezel assembly. Once its heated up, you will be able to move the insert, and it will lift off. Quote Link to comment Share on other sites More sharing options...
AyJayKay Posted July 11, 2015 Author Report Share Posted July 11, 2015 Many thanks Sent from my iPad using Tapatalk Quote Link to comment Share on other sites More sharing options...
SSTEEL Posted July 12, 2015 Report Share Posted July 12, 2015 Let us know how you get on. Once heated, if the insert still doesn't lift up, try using the edge of a razor blade. Providing that the insert has not been glued in place from say, a previous owner, you should be fine. Quote Link to comment Share on other sites More sharing options...
Avenue Posted August 1, 2015 Report Share Posted August 1, 2015 Where did you buy the new insert from? I have the same issue. Quote Link to comment Share on other sites More sharing options...
AyJayKay Posted August 2, 2015 Author Report Share Posted August 2, 2015 Where did you buy the new insert from? I have the same issue. I got a Parnis ceramic off eBay. Unfortunately the numbers are too white and the pearl is too recessed, But it looks a lot better than the one with missing numbers, I have given it to my watchmaker to fit. When I get one that is a better match to the gen, I will swap it out again. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.