How to add links to a DSSD?

[zaazaa]

Hi,

I just purchased a nice DSSD, but the bracelet is too small so I need to add a link (the fine adjustment piece, if that's what you'd call it, is pulled all the way out).

Is this something I can do myself?  I'd hate to have to take it to a watch dealer for obvious reasons, but not sure.  

I see the very small philips head screws on a few of the bottom links.  Do I need to remove one of the screws and add a link between one of the links that's attached to the bracelet on either side (I don't see how I could add something at the very bottom of either side)?   

I looked on youtube but the vids dealt with other Rolex watches.  

Thanks for helping a noob! :-)   It's driving me crazy that I can't wear the thing.

[gingerr6]

Just remove 1 screw from anywhere on any side And fit the new link.

Sent from my HTC One using Tapatalk

[zaazaa]

Thank you.  Based on experience, would it be ok if I use any small screwdriver (I think I have the standard set you can get anywhere) or should I order one of those "use this for your rolex watch" $20 screwdrivers?  

thanks again

[gingerr6]

As long as it fits anything will do

Sent from my HTC One using Tapatalk

[zaazaa]

As long as it fits anything will do

Sent from my HTC One using Tapatalk

LOL - got it.  I was just able to take care of it.  Thanks once again.  

Discovered some of the edges of the clasp are a bit sharp (guessing un-rolex like) but I'll try to figure out how to deal with that.