Since i read ttks post about the artos/subs, i figured i would give a helping hand

[rbj69]

this stuff hardens like steel and u can grind on it and everything , i figure if u can use it to bond metal parts on aircrafts, surely it will hold your arktos and submersible bezel markers in place in order to get the markers out to reglue them i recommend u remove the bezel which is hard to do and then heat the indices till the heat breaks up the existing superglue and then pull them all out and clean them and then take a piece of sandpaper and make some scratch marks on the bottom on the indices and in the bottom of the hole to insure a good bond and then put a dab of this metalset in there and press them down once done with all sit a book on top of the bezel to keep pressure on the markers so they will set and seal good , hope this helps u