Jump to content
When you buy through links on our site, we may earn an affiliate commission.
  • Current Donation Goals

My Little Guide: Smp Chrono How To Install Pins


Moppel

Recommended Posts

My little guide: How to install pins on an OMEGA SMP Chrono

Even though I loved my Chrono from the very first time I received it, there was one

flaw that bothered me: The bracelet is using screws instead of pins.

So I began thinking about how to change from screws to pins.

Here is how I did it and what tools and parts I used.

First of all you need these little pins. Diameter is 1.2mm, the notched part has a diameter of 1.4mm.

195456-3573.jpg

Available here at Cousins

I had to shorten the length to 19.7mm

This is how the bracelet looked before modification.

195456-3574.jpg

195456-3575.jpg

I used a drill diameter 1.2mm to drill the old screw thread.

195456-3576.jpg

195456-3577.jpg

This would be the side where you wanna install the pins.

Note that this is the side where the notched end of the pins has to be ( the drilled end )

You really have to use some force to install the pins. So I used a brass pin to put the pins

in the right position in order to avoid any damage to the bracelet.

And finally here is how it looks like.

195456-3578.jpg

195456-3579.jpg

To me it was fun doing it and now this beauty is a bit closer to the gen :-)

I hope my little guide is understandable as I am not a native english speaking person.

Cheers

Moppel

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...
Please Sign In or Sign Up