Vintage Rollie Experts-6263

[yt74]

I bought this from a member on another board for a good price, but it had some problems, one being a stuck pusher. Apparently the previous owner had dropped it on the floor and broke one of the pushers. The guy I bought it from had got the pusher to work but it was permanently half screwed in. I thought it would be an easy fix, but when I got it apart I can't figure it out. When I disassembled and re-assembled the functioning pushers I think I broke off the other pusher stem, because they both look the same. I have been looking all over the board for something that would help, but it seems like most of what I found concerns the DW 6263 and not the Seagull hand wind like this one. Anybody have any ideas or at least somewhere to get parts?

[bertieng]

I bought this from a member on another board for a good price, but it had some problems, one being a stuck pusher. Apparently the previous owner had dropped it on the floor and broke one of the pushers. The guy I bought it from had got the pusher to work but it was permanently half screwed in. I thought it would be an easy fix, but when I got it apart I can't figure it out. When I disassembled and re-assembled the functioning pushers I think I broke off the other pusher stem, because they both look the same. I have been looking all over the board for something that would help, but it seems like most of what I found concerns the DW 6263 and not the Seagull hand wind like this one. Anybody have any ideas or at least somewhere to get parts?

You need a need pusher, or at least the push button with the stem intact. I will try to look into my tray to see if I have one for you. Will let you know.

[yt74]

You need a need pusher, or at least the push button with the stem intact. I will try to look into my tray to see if I have one for you. Will let you know.

Thanks, I actually need 2, I broke the other one messing around with it...

If you don't have any spares a recommendations on where to buy one would be appreciated.

[RWG Technical]

Most pushers are standard sizes, normally 2.5mm case thread size.

You should be able to source some generic pushers to replace these. Ofrei is asking $42 each for replacements, I think I have a supplier that probably carries them for less, but would have to look...

If I forget to look please try and remind me, keeping in mind my pm is shut down for a while.

RG

[bertieng]

If I am not wrong, those from Otto is not the correct ones for the vintage model, rather they are for the modern Daytona.

Please correct me if I am wrong.

[yt74]

If I am not wrong, those from Otto is not the correct ones for the vintage model, rather they are for the modern Daytona.

Please correct me if I am wrong.

I think you are correct.