stilty Posted October 10, 2007 Report Share Posted October 10, 2007 I am looking into getting a couple of movement holders made for direct drop into 3135 cases. These would be for ETA 2892-A2 movements. I'm not really looking at any other movements right now, as we can use the ETA enlargment rings for 2824-2, and 2836-2. I have yet to find a solution for the 2892-A2s so I guess I have to get them made. These will be exact fit for the movement and genuine case, with perfect stem alignment, proper case clamp positon, etc. I can get them made out of pretty much any material. I'm thinking brass would be a good choice. I don't know if anyone else would be interested. Right now, a one off will cost me $150.00, if I get two, it will be around $90 each. So if anyone else is interested, I can have more made at the same time to spread out the cost. Estimated cost for additional units is between $25-$35. Shop rate is $75.00/ hour, so until the first one is made, I won't have an exact cost per unit. It could take 20 minutes per unit or 30 minutes, depending on how many cuts are required. drop me a PM or reply if interested. The shop is booked until the end of the month, and I have to drop off a case and movement to get the first one spec'd. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.