movement holders / spacers for franken projects

[stilty]

I am looking into getting a couple of movement holders made for direct drop into 3135 cases. These would be for ETA 2892-A2 movements. I'm not really looking at any other movements right now, as we can use the ETA enlargment rings for 2824-2, and 2836-2. I have yet to find a solution for the 2892-A2s so I guess I have to get them made.

These will be exact fit for the movement and genuine case, with perfect stem alignment, proper case clamp positon, etc. I can get them made out of pretty much any material. I'm thinking brass would be a good choice.

I don't know if anyone else would be interested. Right now, a one off will cost me $150.00, if I get two, it will be around $90 each. So if anyone else is interested, I can have more made at the same time to spread out the cost. Estimated cost for additional units is between $25-$35. Shop rate is $75.00/ hour, so until the first one is made, I won't have an exact cost per unit. It could take 20 minutes per unit or 30 minutes, depending on how many cuts are required.

drop me a PM or reply if interested.

The shop is booked until the end of the month, and I have to drop off a case and movement to get the first one spec'd.