TAG Link micro adjustment

[LordRasta]

Ok it is time for me to give back to the forum. This is for those of you that don't know how to micro adjust the TAG Link bracelet. Position your watch like in this picture courtesy of By-Tor:

There are holes on both sides where the clasp meets the link, it looks like nothing is there. Take a VERY small screwdriver and push inside one of the holes. You will feel a spring, push it all the way in then gently pull the clasp away. You will find that there is a short spring bar holding it together. Make sure the spring bar doesn't get away from you. Again with the watch positioned like the picture, you want to put the bar back in the 3rd hole to the right. Basically you are putting the clasp closer to the link it is attached to which will make the bracelet a little smaller when you put it on, but when closed it will make the bracelet a little bigger. If you use the first hole on the left (again based on this picture) the bracelet will seem larger when you put it on, but will close up smaller. I hope this helps someone.

[mikellem]

Thanks very much!

Great tip..

-MM

[By-Tor]

Very good info LR. Thanks man.

Someone told that the spring can fly like a bullet when you release it (if you're not careful).

[r11co]

History repeats itself

[LordRasta]

History repeats itself

@r11co - I saw you had already went down this road after I posted this. Let the record show you figured it out first. :-)