CG dimensions needed for design work (non DSN PAMs historic series)

[Fish]

Hello everybody!

I would like to have a little comparison on certain diimensions:

Could you check the width of the CG chamber where the crown is in? I

Edited May 28, 2008 by Fish

[StormTooper4]

MODEM BURNER WARNING , will remove if required

Sorry Fish I don't have an electronic ruler.

These might be useful if you can get the scale right.

Hope they help, and good luck with your quest

ST

[Fish]

MODEM BURNER WARNING , will remove if required

Sorry Fish I don't have an electronic ruler.

These might be useful if you can get the scale right.

Hope they help, and good luck with your quest

ST

Thank you ST, niche drawings, but rather decorative. I took the required dimensions from a Joshua PAM and just want to find out if others are close to these dimensions to make sure that part will fit most PAM reps without or with only minor further corrections to CG lever od gasket thickness.

Come on fellows, I am sure I

Edited May 28, 2008 by Fish