Fish Posted May 28, 2008 Report Share Posted May 28, 2008 (edited) Hello everybody! I would like to have a little comparison on certain diimensions: Could you check the width of the CG chamber where the crown is in? I Edited May 28, 2008 by Fish Quote Link to comment Share on other sites More sharing options...
StormTooper4 Posted May 28, 2008 Report Share Posted May 28, 2008 MODEM BURNER WARNING , will remove if required Sorry Fish I don't have an electronic ruler. These might be useful if you can get the scale right. Hope they help, and good luck with your quest ST Quote Link to comment Share on other sites More sharing options...
Fish Posted May 28, 2008 Author Report Share Posted May 28, 2008 (edited) MODEM BURNER WARNING , will remove if required Sorry Fish I don't have an electronic ruler. These might be useful if you can get the scale right. Hope they help, and good luck with your quest ST Thank you ST, niche drawings, but rather decorative. I took the required dimensions from a Joshua PAM and just want to find out if others are close to these dimensions to make sure that part will fit most PAM reps without or with only minor further corrections to CG lever od gasket thickness. Come on fellows, I am sure I Edited May 28, 2008 by Fish Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.