help needed

[repfreak]

Hi,

I am learning to assemble a simple 21j watch, but I am kinda of noob in this...

can you help?

So I just need a

1) 21j Movement

2) a watch casing

3) suitable dial, hour and minute hands,

4) a turning [censored] or crown

Anything that I still need?

[ubiquitous]

You'll need a case set suitable for the movement you're planning on using. Not all cases are compatible with all movements; you definitely need one that allows the movement and stem to line up center in the crown tube, otherwise you risk snapping the stem.

Just what exactly are you trying to build? That might make for providing an easier answer. As the question stands, it's somewhat vague and difficult to really provide any insight to your inquiry...

[repfreak]

I not really sure, I have been looking at http://www.ofrei.com/WatchMaterials.html and I will ask the dealer to recommend a case which can fit the movement... Any part of the watch I still lacking of?

[ubiquitous]

You will likely need a movement ring/spacer and case clamps.

FWIW, Ofrei sells a kit of sorts that includes everything you need, including the movement specific to the case they provide. Might be best to go this route if this is your first time building; it will definitely eliminate the frustration factor, which will make all the difference with your experience in a project like this.

[ubiquitous]

P.S. The Watch Repair & Upgrade section may be of interesting reading to you as well. I would recommend spending some time researching that forum as there is quite a lot of knowledge within.

Good luck.

R

[Paneraibob]

this could be a nice start to build a watch

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...y0%3D%26fvi%3D1

[ubiquitous]

Definitely agree with that. The larger 16.5'" size of the UT and UT clone makes handling the movement much easier for someone starting out.