Raising the Bar on COMEX

[freddy333]

(My watch stem, that is.)

I am looking for suggestions on how to raise the height of the movement to bring the stem entry into the movement (at red arrow) in line with the hole in the case, while still allowing the dial to remain at its present location (against the inside face of the case) & without ending up with the hands rubbing on the face of the dial)

(The arrow indicates the location of the stem opening in the side of the movement)

Here is another angle

I know this is a somewhat tall order, but I seem to recall that someone was able to successfully pull off a similar feat a couple of years ago.

To those who wanted to know what I am working on (bezel/insert for display purposes only)