Help Needed!

[Migge]

Hi everbody...

...so I was to take out the crystal of my watch and I removed the caseback, removed the crown and stem and finaly the movement.

I have my crystal of to Chieftang, thats why, the dumbass I am, felt the need to do this myself.

The problem I have now s that I cant get the stem into the movement. The movement is also working, I mean that the seconds hand is moving even though there is no stem inserted??

Its an asian 21J movement and I need all the help and suggestions I can get!

Regards

Mike

Edited May 6, 2009 by Migge

[Toadtorrent]

I'm assuming you're talking the non-chrono movement. To get the stem back in, you have to depress the stem release button slightly. Don't over-press or you'll screw up the keyless works and that may need a watchmaker to fix.

Turn the stem in the winding position as you stick it in until you start to see things getting engaged, then depress the release button and keep turning the stem slowly as you push it in. It may take a few tries to get things going properly...but make sure not to press the button too hard.

[Migge]

I'm assuming you're talking the non-chrono movement. To get the stem back in, you have to depress the stem release button slightly. Don't over-press or you'll screw up the keyless works and that may need a watchmaker to fix.

Turn the stem in the winding position as you stick it in until you start to see things getting engaged, then depress the release button and keep turning the stem slowly as you push it in. It may take a few tries to get things going properly...but make sure not to press the button too hard.

Thank you very much for the answer!! Its a non chronomovement yes, I wouldnt touch the asian 7750 = )

Im playing with the movement right now and I figured it out..kind of embarrasing but...the movement just wasn