regity

To my knowledge, the plates are made to specs, i.e. 0.4mm top and bottom. Should that be the case, could it be too much lume?!?!

"L SWISS MADE L" remind me of the 253i, leaning to the right... wonder if they are from the same factory

[NEWBIE ALERT!!!] I'm completely new to this, who would be the one to go for this sort of mod+service? Also, if I were to do this, what is involve? I figure getting the pin out is the easy part, but once out, do I simply hammer/push the back of the CG or sand from the front? Appreciate any advice

Hi Pete, thanks for the advice. Contacted seller and replied that there are no parts available; but all pins are pressed to stay in placed. Should that be the case, I guess this will happen even with new parts (or maybe it is just my luck that mine is pressed one notch too hard!!!). Attached is the photo of the affected area.

Just received my PAM212i ultimate and realise that there is a slight indent on the CG where the pin is located. Almost seems like the pin is too big and it was force into the CG which resulted the dent. It can only be seen in certain angle and needless to say, this wasn't pick up in the QC pics. My understanding is that the seller don't carry spares; so, anyone know who does or makes a better CG for the 212 (smaller pin, better "REG TM" positioning etc?