Search the Community

I'll start by saying this, I am not very good at documenting my work but pictures are en route, I also made some Newb mistakes during the dissassembly that I may need help fixing.... alright disclaimers notwithstanding.... I performed my very first keyless works repair last night! This whole issue came about after I got frustrated with a crooked crystal on my DSSD, it has been like this from the time it arrived, over a year ago. I had attempted to press the crystal in, with no luck, in the past but had never taken a watch apart and certainly didn't try that a year ago with I got this watch. This time, I started tapping the crystal (dumb, I know) and in the process I caused the second hand to pop off, the dial to come loose, and the crystal to stay right where it was when I started At this point I knew I had to take the watch apart to replace the second hand and I would just pop the crystal out and re-install it into the watch. (I also had no idea that the dial was loose on the movement at this time). I managed to get the Crystal installed in the case, nice and straight, and simply pop the second hand back on, no problems and I was good to go.... threw the watch on my wrist and took the dog for a walk, and that's when I saw the dial turning freely around inside the case When I got home I took the watch off and opened it up, pulled the movement out and glued the dial to the movement ring (not sure what this part is called but it had come unglued from the ring that connects the dial to the movement. I popped the watch back together only to immediately notice a spec of dust on the dial, and I went back in...... that's when my luck ran out and I finally gummed up the keyless works. It was now 20:00 and I was getting tired, but that didn't stop me. Tonight, between finishing my assembly and taking the dog for another walk, I will update this post with terribly documented repair pictures that show very little detail and will never help anyone, but like I said, I'm no good at documenting anything. Until then, I hope everyone is having a good.....time Mike