titanium cases - sanding down sharp edges?

[landwomble]

My Getatwatch titanium's turned up, and it's a peach. Some edges are a little sharp (well, not actually *sharp* but might mark the leather). What's the best product to remove these with? A file's far too aggressive, would something like Autosol chrome polish be a dumb idea?

[Bike Mike]

Machinist tooling stone. I have used files too, you just need a fine needle file. Any type of polish is not going to cut it.

[lanikai]

emery board. all you ant to do is "dull" the edges... finish with a pen eraser...this will take it back to the original finish.. then you'll be ready to oxidize the metal (if your so inclined)

AC

Lani

[landwomble]

emery board. all you ant to do is "dull" the edges... finish with a pen eraser...this will take it back to the original finish.. then you'll be ready to oxidize the metal (if your so inclined)

AC

Lani

oxidise? as in filing it off will show unoxidised, different colour titanium so I need to do something to get it to match? I'd presumed it'd be like aluminium and cover itself with oxide but maybe not after thinking about it...

[FxrAndy]

Fine emery paper will do the job just fine

[lanikai]

oxidise? as in filing it off will show unoxidised, different colour titanium so I need to do something to get it to match? I'd presumed it'd be like aluminium and cover itself with oxide but maybe not after thinking about it...

no, the pen eraser will bring it back to match the rest of the case.. if it's a Pam the oxidizing with oxi-clean darkens the

Ti to look like the genuine article.. I have somewhere a detailed tutorial of "how to" you need oxi-clean and boiling water.. no noe can seem to locate it though .. it was posted about a year and a half ago. our search engine is being worked on by Admin so finding now is rough..