Jump to content
When you buy through links on our site, we may earn an affiliate commission.
  • Current Donation Goals

Feedback on a PAM 220


bmedude

Recommended Posts

Anyone care to share their thoughts on the PAM 220 sold through Josh? I'm a first time rep buyer and do not really wish to make additional mods. It is a rather expensive rep @ $400+. I tried searching around but haven't found any recent posts on it.

I'll also throw a bit of a curve ball in there.... Would you rather get a DSN ultimate fiddy or a Josh PAM 220 as a starter watch? Budget is $500.

Link to comment
Share on other sites

Thanks. I think I'll end up getting both. I'm just awaiting a response from DSN :)

You're definitely right about that fatty 47mm case. They look unbelievable

Link to comment
Share on other sites

Ultimate 220 sold by cartel = Ultimate 104, w/ a brushed case + SS bracelet.

Same pros and cons found in the Ultimate 104 apply.

+ Decent caseset

+ Great crystal/cyclops

+ Good datefont

- Incorrect CG for I series, rep uses a contemporary looking CG and it should be a tapered-top historic polished w/ brushed lever

- Incorrect caseback (taken from rep 104I) 220I was limited run of 400 units

- 6 o'clock numeral should be open but since it's a recycled rep 104I dial it's closed

- crown too close to case

- L SWISS MADE L too close to 6 o'clock

- CP cap on the hanstack is not polished and has micro lathe swirlies.

those are just a few that come to mind.

Link to comment
Share on other sites

Hrmm, I think I'm going to hold off on the PAM 220 now after reading what you had just mentioned. I'll probably go with a cheaper replica like the PAM 000.

You rock w0lf!

Ultimate 220 sold by cartel = Ultimate 104, w/ a brushed case + SS bracelet.

Same pros and cons found in the Ultimate 104 apply.

+ Decent caseset

+ Great crystal/cyclops

+ Good datefont

- Incorrect CG for I series, rep uses a contemporary looking CG and it should be a tapered-top historic polished w/ brushed lever

- Incorrect caseback (taken from rep 104I) 220I was limited run of 400 units

- 6 o'clock numeral should be open but since it's a recycled rep 104I dial it's closed

- crown too close to case

- L SWISS MADE L too close to 6 o'clock

- CP cap on the hanstack is not polished and has micro lathe swirlies.

those are just a few that come to mind.

Edited by bmedude
Link to comment
Share on other sites

Just decide which one you think looks best, then buy the one appropriate for your budget. Then start "fixing" the flaws one at a time. Then get completely frustrated, and start all over again, if you can't live with the flaws.

Me, I can live with the flaws, and there are so many :)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...
Please Sign In or Sign Up