Jump to content
When you buy through links on our site, we may earn an affiliate commission.
  • Current Donation Goals

Crystal, Gasket, Retaining Ring


preacher62

Recommended Posts

Please tell me if this is correct.

The crystal and gasket presses down over the outside of the rehaut ring (as far as it will go). Then the retaining ring is pressed over the crystal further tightening the crystal/gasket to the back of the rehaut and also providing a mounting mechanism for the bezel ring.

Is this the way it works? Does anyone have a pic of the case without a retaining ring or glass?

Question is...if the above is correct then will a gen retaining ring fit on a Clark crystal (295 C2) in an MBK 16610 case set?

I apologize for my ramblings but I, very much, respect the knowledge base here and just want to make sure that I have it right.

Thanks!

Link to comment
Share on other sites

You've got the right order.

-Gasket fits over the rehaut lip

-Crystal presses into the gasket

-Crystal ring next

-Then washer

-Add click

-Fit bezel ring

-Fit insert so that it lines up with the click and press in slightly

-Remove bezel with insert partially installed and press fit the insert completely

-Fit bezel + insert

Here are some less than great pics of the crysal + gasket minus retention ring:

IMG_0743.jpg

IMG_0749.jpg

Hope this helps...

//ubi

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...
Please Sign In or Sign Up