Noobmariner pearl fall off

[omega64]

Hello,

I weared my noobmariner for less than a week and the pearl have disapeared.

I did not put the watch in any stress, but it fall off the bezel.

I search it around my desk, but i did not find it.

Which one is the best option to replace it?

Where you buy it? How much?

Can i just epoxy it to the place of should i do a more elaborate fixing?

That replicas have some problems sometimes ..........

[ArkoN]

josh gave me a complete bezel with the pearl^^ I removed the old bezel, but dont know whats the best way to stick the new bezel in. The old one was attached with some sort of double side tape.

[alligoat]

Get a $10 watchmaterial pearl and then remove the bezel insert- an X-acto knife works well- pry gently under the insert from the crystal side.

Then enlarge the pearl hole with the knife so the WM pearl fits in tightly, then add a bit of glue. Glue the insert onto the bezel with either G-S Hypo cement or a few drops of epoxy. Don't use too much glue or you'll glue the bezel to the case and it won't turn.

The noob bezel insert is slightly smaller than a gen/aftermarket insert (which requires edge sanding to fit) so I've always reused it in the past.

[omega64]

You know how to explain things !!!!

Thank you !!!

[omega64]

Is there any other watchmaterial piece which is interesting to buy once i should pay shipping to Europe?

To improve more the noobmariner ........

[im2]

I have the same issue on one of my Subs.

So the store is watchmaterial.com ??

[omega64]

yes