Guest porsche356a Posted October 3, 2006 Report Share Posted October 3, 2006 (edited) Hello everyone, I recently purchased a Sub from EL, it is fine except the MAG/cyclops is slightly off. Is there a way to remove and reglue the mag/cyclops so it is perfectly square? Thanks in advace. Edited October 3, 2006 by porsche356a Link to comment Share on other sites More sharing options...
watchlover321 Posted October 3, 2006 Report Share Posted October 3, 2006 That's soo not for me.... yikes.. I'll end up scratching the crystal This has been discussed a few times. It would take a braver man than me... apparently you place a sharp object against the side of the raised cyclops and bang it once... pops right off. Then glue it back! Link to comment Share on other sites More sharing options...
Bazz Posted October 3, 2006 Report Share Posted October 3, 2006 Maybe just push out the crystal then replace with the cyclops centered, ie does it need to be slightly rotated? I have knocked off a cyclops and reglued it before... pain in the ass to do Link to comment Share on other sites More sharing options...
Guest porsche356a Posted October 3, 2006 Report Share Posted October 3, 2006 This has been discussed a few times. It would take a braver man than me... apparently you place a sharp object against the side of the raised cyclops and bang it once... pops right off. Then glue it back! Is there some special type of clue they use? Can anyone point me towards the right direction in terms of glue? Thanks again guys! Link to comment Share on other sites More sharing options...
alligoat Posted October 3, 2006 Report Share Posted October 3, 2006 Actually, UV (ultraviolet) glue is what you're supposed to use. It's clear when it dries. To cure UV glue, you can either put it in the sunlight, or a UV light will cure it. To remove the cyclops, you might try heating up the crystal first, and then try popping the cyclops. There was a discussion over at TRC, happy searching! Link to comment Share on other sites More sharing options...
RWG Technical Posted October 3, 2006 Report Share Posted October 3, 2006 Hello everyone, I recently purchased a Sub from EL, it is fine except the MAG/cyclops is slightly off. Is there a way to remove and reglue the mag/cyclops so it is perfectly square? Thanks in advace. Here is one link... Crystal replacement... and another...lots of info in this subforum... Crystal cyclops... RG Link to comment Share on other sites More sharing options...
Guest porsche356a Posted October 3, 2006 Report Share Posted October 3, 2006 Thanks alot guys! Link to comment Share on other sites More sharing options...
supermanx Posted October 4, 2006 Report Share Posted October 4, 2006 Thanks alot guys! Two tips learned the hard way, cyclops can fragment and the pieces hurt like hell if you step on it (or worse shoot up into your eye) and dont set a hot a$$ crystal on a cold piece of metal or it will crack. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now