1680 bezel issues HELP

[paneristo000]

I pooped of my bezel to do some

aging, but can not get it back on. there is an octogon spring inside, not sure what to do, any advice?

Thaks guys

[Ephry73]

It's easier to put the bezel back without the insert then snap the insert in when using the spring wire setup. E

[paneristo000]

where does the spring wire go in, bezel or the case near the o ring?

[Ephry73]

What case do you have/ There should be a crystal ring with a ledge for the spring to perch on. Without the bezel insert you can use a pen or toothpick to push the wire spring into place then press the insert into place.

E

[paneristo000]

when I try to press the bezel in it will not click into place. I also looks like the bezel insert was glued in. Not sure If I should pop it out. I have the 21j red 1680

[FxrAndy]

A photo of the case without the bezel would help to see exactly what you have

[paneristo000]

It will set back into the case but does not "click" and will fall back out

[woof*]

Do what Ephry says. With the insert off.... use a small tool to poke the wire into place.

[paneristo000]

then it should click back in

[paneristo000]

then it should click back in

[paneristo000]

got it. That was trickier than I thought it was gonna be