Am i being too picky or...

[whiteshields1830]

Am i being too picky to reject this QC picture or do you guys all think that this is quite a big fault in the AP Diver V3?

Circled are the problem screws on the bezel...does it seem to me that theyre not put on properly? or that there are obvious gaps in them?

Uploaded with ImageShack.us

Edited September 10, 2012 by whiteshields1830

[Mr Z]

yes !! its a easy5 min fix !!!

P.s if you don't want it ........ ill take it !!

Edited September 10, 2012 by zorrolondon

[whiteshields1830]

yes !! its a easy5 min fix !!!

P.s if you don't want it ........ ill take it !!

Can you let me know how i can fix it if i do accept it? I thought there was meant to be absolutely no gaps between the screw/bolt and the bezel?

Edited September 10, 2012 by whiteshields1830

[Mr Z]

yes just remove the case back and loosen the case lug washers .. and then just adjust the bezel screws , with a screwdriver until straight ..the re-tighten the lug screws

job done !!

[GreenHornet]

I'm not saying you are being too picky, but I think the gaps that you are seeing at 25X magnification will look perfect in person. Actually I would not pass on that one, the markers are lined up about as good as I have seen on any of the V3 Divers.

[whiteshields1830]

yes just remove the case back and loosen the case lug washers .. and then just adjust the bezel screws , with a screwdriver until straight ..the re-tighten the lug screws

job done !!

I have no idea how what half of that meant haha. Though wouldnt it be best if i got the watch WITHOUT the need to tamper with it to get it right?