PAM029 QC for your expertise comment and advise

[nathanchau22]

Hi all

I have ordered my first rep last week and the TD shown me tge QC would like to seek for your advise and suggestions.

This is my first Rep first Pam and birthday present for myself, so would like to make sure this is good.

I have been working hard for this from internet and here. However experience is more important on this area. Please help

1. Is dials too green?

2. Is number 9 look too fit?

3. Do u think the dark spot at the back is just dirty or wht?

4. Is it Noob Best V2 M series?

5. Any other comment?

Thank u for your help

[Mike on a bike]

No Pam expert but all in all looks OK, sure the guys will find flaws but all reps have flaws.

 

Here is the noob v2:

 

 

GEN

 

 

[nathanchau22]

Your noob v2 qc pic look beter than mine.

Do u think my one number 9 look too fit

[Mike on a bike]

"too fit" do you mean close?

[nathanchau22]

Sorry i meant fat sorry for typo

[nathanchau22]

The back or tail or right hand dont know how to describe look fat than usual

[Mike on a bike]

I get what you are saying and yes looks a bit thicker than the gen “9 " also a little less defined on the close of the 9 but hey like 7-8 grand less, temper your expectations it is a rep.

[nathanchau22]

Thank you man, i know it is a rep there must be little different compare with Gen. However, now would like to compare with indentical Rep as quality control.... as compare with your rep photo and your comment, i think the number 9 do has problem .... and noticiable....

 

The numebr 9 from mine rep  is thicker than your rep photo...

 

Thank you very much...

[coffindodger]

i think it looks ok i would take it , like Mike says its a rep its not going to be 100%. If you ask for another it will probably look the same and your just wasting time when it could be in the post.

[xpletiv]

It's too clean to be a mistake, like a blob or smudge. The next couple hundred may look the same=same batch, so you'll be wasting the time and patience of the TD.

And if you know its a Rep then accept Rep faults.

If the number was crooked or peeling off that's another thing. And most won't know the difference even if you point it out.

[405356momo]

Number on the bezel to big

Edited October 7, 2014 by 405356momo