ct83 Posted January 3, 2015 Report Share Posted January 3, 2015 Hi watch lovers, My PAM 111 which is of course handwinding wont wind anymore. The hands/ finger are turning in any position of the crown. It starts working but only 10 minutes if i turn the crown with working hands. The original Winding isnt working. When you screw you Can not feel the normal resisitance when turning the crowne . Can anyone help? Link to comment Share on other sites More sharing options...
chris5264 Posted January 3, 2015 Report Share Posted January 3, 2015 Is the back off or did the stem just come out? Link to comment Share on other sites More sharing options...
ct83 Posted January 3, 2015 Author Report Share Posted January 3, 2015 It come out? Who Can repair? How much is it? Link to comment Share on other sites More sharing options...
Uberscreamer Posted January 3, 2015 Report Share Posted January 3, 2015 If the stem pulled right out, and was not giving typical resistance for winding and setting, it sounds to me like your set screw may have loosened up on you. It is an easy fix if you have a case back opener for your PAM. Once open, it should be pretty evident which of these screws on the plate is the set screw, but if you are not comfortable with technical components, I may advise not to open and attempt to fix this. Also, as a side note, that Panerai logo on the dial is a dead giveaway that it is not an 111, but more likely a 005 that you have in your possession. Especially if this has a solid case back. Best of Luck Link to comment Share on other sites More sharing options...
asciwhite Posted January 3, 2015 Report Share Posted January 3, 2015 Take off case back. Put stem in hole Tighten screw Try to pull out and set time and wind. If ok close back up and finish. Link to comment Share on other sites More sharing options...
chris5264 Posted January 3, 2015 Report Share Posted January 3, 2015 Lots of stuff here on how to get off a solid back..should be the only hard part depending on how tight it is. Link to comment Share on other sites More sharing options...
alexfilipov Posted January 4, 2015 Report Share Posted January 4, 2015 Use a sticky ball/gloves/rubber ball if you do not have an opener. Link to comment Share on other sites More sharing options...
ct83 Posted January 8, 2015 Author Report Share Posted January 8, 2015 Got the rubber ball. Nice try. Now ordered opener via ebay. Gesendet von iPad mit TapatalkBut Hey, the tip is quite good. Hope this Can be fixed like you described. Thanks a lot Gesendet von iPad mit Tapatalk Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now