Polishing Engraving On Ingy Caseback

[Devedander]

So my Ingeniur had very sharp edges on the caseback, namely the indentations where the removal tool goes (these were VERY sharp edges) and the engraved writing has a definite sharp feel to it when you run your fingers over it.

On the back of my wrist for a few hours this starts to get a sort of annoying "itch" (like a tag on a shirt that rubs on the back of your neck) so I took some time to file down the notches for the caseback tool (still going to have to do that more) but the writing needs work too... but I can't think of a good way to go about it...

It's brushed so I can't just polish it or sand it and it's too definied to use a file or sandpaper on it...

Any suggestions on how to soften the enges on this engraving in this situation?

Thanks for any advice!

[pizzanooo]

Somewhere in the past I had read the hard eraser you find on the end of a pen, worked well. Tried it on a Vacheron caseback I had and worked very nice.