dadog13 Posted April 3, 2006 Report Share Posted April 3, 2006 well, i know that this was asked before..but on this new forum i don't think it was asked till now.. so, my question is simple...HOW DO I FIX IT? the good thing is that i found the pin, so practically nothing is missing... i have the pin...the lever...i tried to put it inside but it simple comes out again... so, my friends...PLEASE HELP ME! Link to comment Share on other sites More sharing options...
new & improved osteopath Posted April 3, 2006 Report Share Posted April 3, 2006 The pin on the 196 is different from that on the others I have worked on, in that instead of being more or less 'pressure fit' the two I have seen have used adhesive to hold them in. The way I fixed them both was with a metal repair epoxy. Take a pin or toothpick and coat the inside of the SMALL hole on the cg wih the epoxy. This prevents it from being pushed through onto the pivoting part and freezing it up. Then push the pin through, being sure to carefully remove the excess epoxy from the outer surface with a knife blade. Wiggle the lever around a few times to make sure it moves freely. -O Link to comment Share on other sites More sharing options...
dadog13 Posted April 4, 2006 Author Report Share Posted April 4, 2006 The pin on the 196 is different from that on the others I have worked on, in that instead of being more or less 'pressure fit' the two I have seen have used adhesive to hold them in. The way I fixed them both was with a metal repair epoxy. Take a pin or toothpick and coat the inside of the SMALL hole on the cg wih the epoxy. This prevents it from being pushed through onto the pivoting part and freezing it up. Then push the pin through, being sure to carefully remove the excess epoxy from the outer surface with a knife blade. Wiggle the lever around a few times to make sure it moves freely. -O tnx for your help @new & improved osteopath! i am sure this happend to some of you guys...so are there any other solutions...don't keep the answers for yourself...help me! Link to comment Share on other sites More sharing options...
dadog13 Posted April 4, 2006 Author Report Share Posted April 4, 2006 bump... c'mon guys...I know you have some other solutions... Link to comment Share on other sites More sharing options...
new & improved osteopath Posted April 4, 2006 Report Share Posted April 4, 2006 I am not clear what other solution you are looking for. If the pin were a pressure fit, you could just tap it back into the hole, however since it is not, you are looking at some sort of adhesive. Metal repair epoxy is the strongest of this type, and is readily available. Since there are no replacement CGs for the daylights as far as I know, this is the solution. There are two other, far more complicated solutions: 1) Manufacture a central pin approx .001 mm wider in diameter with a tapered end so that it can be pressure fitted into the hole. 2) Purchase an arc welding tool, and braze it onto the CG, and then repolish it with progressively finer wheels. -O Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now