finisterre Posted March 30, 2007 Report Share Posted March 30, 2007 It's my first serious rep, and I guess I ought to start learning how to do things on it myself. Thanks. Link to comment Share on other sites More sharing options...
fitmic Posted March 30, 2007 Report Share Posted March 30, 2007 Take it to your local watch repairman. This bracelet is a B!TCH! Link to comment Share on other sites More sharing options...
finisterre Posted March 30, 2007 Author Report Share Posted March 30, 2007 Take it to your local watch repairman. This bracelet is a B!TCH! I don't wanna resize it. Just be able to swap straps at will. Link to comment Share on other sites More sharing options...
cornerstone Posted March 30, 2007 Report Share Posted March 30, 2007 You just need a spring bar tool - inexpensive and easy: (Pic taken from Narikaa's section) Good luck! Link to comment Share on other sites More sharing options...
fitmic Posted March 30, 2007 Report Share Posted March 30, 2007 I don't wanna resize it. Just be able to swap straps at will. Sorry! I didn't pay too much attention to your question. A springbar remover is what you need. Link to comment Share on other sites More sharing options...
Watchmeister Posted March 30, 2007 Report Share Posted March 30, 2007 IMHO, swapping the bracelet is fairly easy. Changing the links does require an experienced watchsmith. Link to comment Share on other sites More sharing options...
Roland Posted March 30, 2007 Report Share Posted March 30, 2007 I changed my links without problem, it just takes a lot more time than usual. The pins are not the usual split-pin design. There is a sleeve in the center piece that gives a very tight fit. This sleeve will fall out when you remove the pin and has to be inserted before the pin is driven back. Resizing the bracelet is easy if you have a pin removal tool, e.g. item FB-506 from Otto Frei (http://www.ofrei.com/page237.html). The tool comes with three attachments of different lengths. Start with the shortest and push out the pin as much as you can in arrow direction. Then take the next longer one and push out the pin more. With the longest attachment you should get out the pin more than half of its length. Then take pliers and pull out the pin. Don't loose the sleeve, it will fall out at this point. For inserting the pin I used a hammer, now against arrow-direction. It will go easy through the first piece of the link since there is no sleeve. Then you need to get it into center-piece with the sleeve. This needs some force and I was not successful pushing it in. So, that's where the hammer comes in. Drive the pin in until only 1 or 2 mm stick out. Then use the pin remover tool with the shortest attachment, align it with the sticking-out pin and push it back in all the way. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now