DuDro Posted November 1, 2007 Report Share Posted November 1, 2007 Does the crystal on a 44mm case just pop out by pushing from the inside? Or do I need to remove the bezel first? I tried searching for this, but was not able to find any previous threads discussing this. Please advise...Thanks in advance! Link to comment Share on other sites More sharing options...
RWG Technical Posted November 1, 2007 Report Share Posted November 1, 2007 It should just pop out, I am not aware of any PAM model that requires the bezel be removed before pressing the crystal out. What model of watch is this? RG Link to comment Share on other sites More sharing options...
DuDro Posted November 1, 2007 Author Report Share Posted November 1, 2007 It should just pop out, I am not aware of any PAM model that requires the bezel be removed before pressing the crystal out. What model of watch is this? RG A 036...Just tinkering around... Link to comment Share on other sites More sharing options...
RWG Technical Posted November 1, 2007 Report Share Posted November 1, 2007 It pushes right out with the crystal press...no bezel removal needed. RG Link to comment Share on other sites More sharing options...
Dizzy Posted December 5, 2007 Report Share Posted December 5, 2007 i have a pam127 fiddy and the crystal broke.. angus is sending me a new saphire crystal.. hopefully this swap will be as easy as it sounds Link to comment Share on other sites More sharing options...
Dizzy Posted February 27, 2008 Report Share Posted February 27, 2008 I've been searching and cant find a tutorial on pam crystal swapping and or bezel removal.... well i finally received a new saphire AR crystal for my fiddy. It comes with the bezel already attached to the crystal. How do i get the old bezel off the watch? Just a razor blade and a sledge hammer? I have the proper crystal press ready to go. The nylon press is about the same diameter as the inside of the bezel so it should work. Or maybe i should just pop the crystal out of the bezel and not remove the bezel on the watch? whats you guys thoughts on this? Link to comment Share on other sites More sharing options...
milsub5517 Posted March 1, 2008 Report Share Posted March 1, 2008 Question: How do you make sure that the crystal will fit right and water will not get in during swimming? are there any o-rings or some kinda sealing material? Link to comment Share on other sites More sharing options...
HauteHippie Posted March 2, 2008 Report Share Posted March 2, 2008 I've been searching and cant find a tutorial on pam crystal swapping and or bezel removal.... well i finally received a new saphire AR crystal for my fiddy. It comes with the bezel already attached to the crystal. How do i get the old bezel off the watch? Just a razor blade and a sledge hammer? I have the proper crystal press ready to go. The nylon press is about the same diameter as the inside of the bezel so it should work. Or maybe i should just pop the crystal out of the bezel and not remove the bezel on the watch? whats you guys thoughts on this? I'm sure you could go either way... My inclination would be to remove the new crystal from the bezel using a hollow die to support the perimeter of the bezel as you press it out with a smaller diameter die from the inside. Reuse the compression ring when you install it into your current case. The only reason I'd do it this way is to prevent dinging/marring the case which can happen sometimes when trying to pry off a bezel. But if you think you can pop off the old bezel without incident, then go right ahead and do so, and then just use a large hollow die to press in the new bezel crystal assembly together. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now