A specific question on CG modding

[DemonSlayer]

I have a particular question on CG modding. I want to do this on my SSD in the near future, it's not so much for accuracy purposes, but merely that I like a challenge and don't like chickening out when it comes to modding that is relatively easy to do.

I've been studying the cg's on the SSD, and it seems that the metal that needs to be removed in the part just under the beginning of the CG's, (near the case). However, if metal is removed here, it appears that the CG's wont be straight, unless I remove metal under the 'pointy' areas.

But then when I look at the area under the pointed section, it looks to be very similiar in thickness to the gen, so removing metal here would make them thinner, and so incorrect.

Am I thinking correctly, or have I missed something here?

[alligoat]

Basically you're trying to remove metal at the two bottom corners. Keep a slight angle on the crown guards- but make it less, especially at the bottom.

Here's a watch from ebay- check the gens and use them as a go by:

http://cgi.ebay.com/ROLEX-SEA-DWELLER-SUBM...%3A1%7C294%3A50