sergio789

yeah, it's minor but still noticeable. I rejected two orange bezel Seamasters based on QC. Skewed "er" just poped out on me. Will wait for makers to rectify that and will reorder again then.

check out my post re "seamaster" potential alignment problem. unable to clearly see this one on your pic, but would be keen to hear your opinion on that. Thanks S

hey folks, wondering what your opinion on that one would be. That is a QC pic, looks like "er" in Seamaster is skewed upwards. Is that the case, or it might be spherical chrystal effect. Cheers S

hey fellas, got a few piecies where I'm lacking on movt decoration (Constellation and Aquaracer). TD listed them with decoration but I ended up without:(( Wondering if there is someone who can perform stellar job on my two units and make both look better from the underside. Thanks S

Leprous-Bilateral; Arch/Matheos-Sympathetic Resonance; Opeth-Ghost Reveries; Quidam-Along Together... list goes on

gday folks. Looking to expand on 42mm PO in orange with both leather and steel bracelets. Wondering how easy it'd be to swap leather for steel and vice versa. Will I be able to do that on my kitchen bench? With minor tools and skills. Any thoughts on the whole project? Or I'll be better off with either leather or steel. Cheers.

supplier has offered to try and fix skewed installation. So I'll flick it over to PRofC in the next few days and hope for the best. Mainly if the package goes OK in reverse. Might end up with a truly "hand made" version of HBB , at least will get extra attention on assembly aspect.

Thanks guys. I realise there is an inner case and multiple outer pottery bits etc. My point is... do I need to hassle supplier for a fix or is it a waste of time and courier $$$ as all other rep HBBs are the same? Cheers

see how light goes through the gap in caseset above the reset pusher (behind the crown)? Not saying it's wrong, wondering if it's normal, acceptable etc. And if other Evolutions are the same.

attaching a pic...

hey fellas. just got my Evolution Red Magic. Seems that case assembly quality might be an issue. There is a sizeable gap between case mid section and top plate (the one under bezel) by the crown. It is visible if you look into the light through it and I can also stuff a thin sheet of paper in it. Wondering if others might have the same thing going on. And if that might render "water tightness" useless. Moisture and dust can easily penetrate the mech and damage it. Tried tightening those two little screws on either side of crown to no avail. Any feedback would be appreciated. Cheers

gday folks. Placed order for Omega Constellation 38mm SS/Gold SW-200 with PClones. Cant wait to lay my hands on it. Will do my best to put out some high res images on receipt. Stay tuned...

hey guys, wouldn't mind to grab one for myself as well. Are you able to send me a link to trusted site? Thanks heaps. Couldn't find that list of trusted sellers everyone's raving about...