hackR Posted November 28, 2010 Report Share Posted November 28, 2010 Is there a simple way to do this?...instructions with or without pix are welcome... Need to do a teardown to replace hacking lever... Thx...R Quote Link to comment Share on other sites More sharing options...
FxrAndy Posted November 28, 2010 Report Share Posted November 28, 2010 have a look mate Quote Link to comment Share on other sites More sharing options...
hackR Posted November 28, 2010 Author Report Share Posted November 28, 2010 Hey Andy...thanks... Do I manually move the lever, while letting the crown unwind? I assume the "remove next" on the screws is to remove the top bridge, right? R Quote Link to comment Share on other sites More sharing options...
FxrAndy Posted November 28, 2010 Report Share Posted November 28, 2010 Correct on both counts, if you wind the crown the pin will move out of the teath you can then hold it back with a sharp bit of peg wood while the power runs off Quote Link to comment Share on other sites More sharing options...
hackR Posted November 28, 2010 Author Report Share Posted November 28, 2010 as always, you rock, Andy!... much thanks...R Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.