grifter Posted January 25, 2011 Report Share Posted January 25, 2011 I recently took my SSD apart. I had a semi-difficult time getting the bezel off.. My question is: When you place a bezel on a flat surface, should it lie flat or is there some curve to it? Did I bend the bezel while taking it off?! Quote Link to comment Share on other sites More sharing options...
jmb Posted January 26, 2011 Report Share Posted January 26, 2011 I would think it should lie flat... Quote Link to comment Share on other sites More sharing options...
z80 Posted January 26, 2011 Report Share Posted January 26, 2011 It should be flat.. I think you bent it. Quote Link to comment Share on other sites More sharing options...
grifter Posted January 26, 2011 Author Report Share Posted January 26, 2011 UUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUGH... guess i'll be looking for another bezel.. Recommendations? Quote Link to comment Share on other sites More sharing options...
sneed12 Posted January 26, 2011 Report Share Posted January 26, 2011 Bend it back flat. I've done that before, and I've never not been able to get it back to flat. Unless you taco'ed the bezel so bad that you cracked it, with patience and a firm hand you should be able to get it back to normal. Quote Link to comment Share on other sites More sharing options...
sneed12 Posted January 26, 2011 Report Share Posted January 26, 2011 Bend it back flat. I've done that before, and I've never not been able to get it back to flat. Unless you taco'ed the bezel so bad that you cracked it, with patience and a firm hand you should be able to get it back to normal. Quote Link to comment Share on other sites More sharing options...
z80 Posted January 26, 2011 Report Share Posted January 26, 2011 I've had to reshape a bezel or two before.. I found it easiest to do on the edge of a table or desk... Also, if you put it on a train track, that will do the trick as well. Quote Link to comment Share on other sites More sharing options...
JoeyB Posted January 26, 2011 Report Share Posted January 26, 2011 UUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUUGH... guess i'll be looking for another bezel.. Recommendations? Yep, the bezel should be flat. It seems that I've bent most of the ones I've taken off. What I've done is to take two pieces of wood with the bezel in the middle, sandwiched, and placed it all in a vise and slowly squeezed it. If the wood is too soft the bezel will embed in it and you'll need to dig it out. It usually takes a few times, rotating the bezel each time, to get it almost flat. I haven't gotten one perfect yet, but it's so close that there is no problem. Quote Link to comment Share on other sites More sharing options...
grifter Posted January 26, 2011 Author Report Share Posted January 26, 2011 thanks guys! i will give it a go. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.