rolli Posted April 29, 2011 Report Share Posted April 29, 2011 hi everybody, i need some measurements of the genuine pam 104 or similar auto pam. see images enclosed. case body tallness = measure A bezel tallness = measure B bezel upper edge beside the sapphire = measure C bezel lower edge = measure D upper lug-horn step to case edge = measure E upper lug-horn step to case edge = measure F it would be very nice you could help. also a reply via PM is welcome. many thanks rolli Quote Link to comment Share on other sites More sharing options...
ocram Posted April 29, 2011 Report Share Posted April 29, 2011 You need them from a gen or rep? Quote Link to comment Share on other sites More sharing options...
rolli Posted April 30, 2011 Author Report Share Posted April 30, 2011 many thanks for the advice. of course the genuine one. rolli You need them from a gen or rep? Quote Link to comment Share on other sites More sharing options...
PeteM Posted April 30, 2011 Report Share Posted April 30, 2011 A = 7.53 B = 4.57 C = 1.07 D = 1.65 (measured from edge of bezel to edge of case...not along the angle) E = 0.59 F = 1.23 Best I could do mate... hope it helps Quote Link to comment Share on other sites More sharing options...
rolli Posted April 30, 2011 Author Report Share Posted April 30, 2011 heartfelt thanks.....pete of course it helps a lot. rolli A = 7.53 B = 4.57 C = 1.07 D = 1.65 (measured from edge of bezel to edge of case...not along the angle) E = 0.59 F = 1.23 Best I could do mate... hope it helps Quote Link to comment Share on other sites More sharing options...
PeteM Posted April 30, 2011 Report Share Posted April 30, 2011 No Probs Rolf If you need any other measurements or angles just let me know Quote Link to comment Share on other sites More sharing options...
rolli Posted April 30, 2011 Author Report Share Posted April 30, 2011 A = 7.53 B = 4.57 C = 1.07 D = 1.65 (measured from edge of bezel to edge of case...not along the angle) E = 0.59 F = 1.23 dear pete, the measure B must be rather 3,57 mm ???? could you check it again ??? rolli No Probs Rolf If you need any other measurements or angles just let me know Quote Link to comment Share on other sites More sharing options...
PeteM Posted April 30, 2011 Report Share Posted April 30, 2011 No probs R Its defintely that measurement got the same again... trying it numerous times mate but please allow +/- 0.03 tolerance I also measured it with a couple of rulers and both were over 4mm less than 5mm Quote Link to comment Share on other sites More sharing options...
rolli Posted April 30, 2011 Author Report Share Posted April 30, 2011 PM sent rolli No probs R Its defintely that measurement got the same again... trying it numerous times mate but please allow +/- 0.03 tolerance I also measured it with a couple of rulers and both were over 4mm less than 5mm Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.