correct case for my project?

[curlflash]

Hello,

I as a 1680 project and I want to know if this case can receive a bezel set.

Thank you for your answers!

[jmb]

The lug holes look a tad large. Are you going to go with solid lug bars? But, maybe my eyes are playing tricks on me...

[curlflash]

no, just GN spring bars installed.

With the measures on the picture 2 , do you think I can install a correct bezel set?

[curlflash]

"on the picture 3"...sorry

[curlflash]

anyone to tell me if the measurements are good to install an Bezel set on this case? :/

Thank you very much

[highoeyazmuhudee]

it looks like it can accept a gen assembly. its hard to see. however your crown position looks especially low on this case

[FxrAndy]

Yep the crown does look low in deed

is ths a DW case?

[curlflash]

Thx very much

"DW"? (sorry, I'm new).

In this case, I installed a GN 703 crown and an Clark 25-127.

But I do not know if I can install one Bezel set with an internal diameter of 30mm.

Edited February 16, 2012 by curlflash

[FxrAndy]

If a clarks crystal fits well then a gen or MBW bezel set should fit as well

DW is david wong

[curlflash]

Great, thank you for the answer.

No, not a DW, I bought this case on a site selling the same watches as Josh (bigbigwatch...) and there was just the Bezel which was supported by a plastic ring...

[FxrAndy]

I think JMB is the person to speak to about a custom crystal and bezel retaining ring, made to fit the bezel you have and the case and crystal

[curlflash]

Yes thank you, I sent a message JMB.

Again thank you for the answers